Endress+Hauser Liquicap M FTI51 - Page 21

Liquicap M FTI51, FTI52 Installation
Endress+Hauser 21
Rod probes ø14, rope probes
For pressures up to Max. 25 bar (depends on flange) -- 25 bar 16 bar
(tightening torque
10 Nm)
Version / order code EN / B**
ANSI / A**
JIS /K**
-- G 1 / GWJ Universal adapter / UPJ
Dimensions H2 = 57 -- H2 = 27
H3 = 30
AF = 41
H2 = 57
Additional information Also clad (PTFE) -- Welding neck
see "Accessories"
EHEDG*, 3A*
Universal adapter
see "Accessories"
Rod probes ø16, rope probes
For pressures up to Max. 100 bar (flange-dependent)
Max. 50 bar (for active buildup
compensation)
-- -- 16 bar
(tightening torque
10 Nm)
Version / order code EN /B**
ANSI /A**
JIS /K**
-- -- Universal adapter / UPJ
Dimensions H2 = 66 -- -- H2 = 57
Additional information Also clad (PTFE) -- -- Universal adapter
see "Accessories"
Rod probes ø22, rope probes
For pressures up to Max. 50 bar (depends on flange) -- -- --
Version / order code EN /B**
ANSI /A**
JIS /K**
-- -- --
Dimensions H2 = 110 -- -- --
Additional information Only clad (PTFE) -- -- --
* The EHEDG, 3A certificate only applies to probes with a fully insulated probe rod. It does not apply to probes with an inactive length
or active buildup compensation.
** Wildcard for nominal diameter and permitted process pressure
Note! Only use clad flanges for aggressive liquids!
Flanges Hygiene connection Hygiene connection Hygiene connection