Endress+Hauser Liquiline CM442R - Page 17

Liquiline CM442R/CM444R/CM448R Installation
Endress+Hauser 17
.
.
.
. .
.
.
.
..
.
.
.
.
.
. .
.
.
.
..
.
.
4 x Ø 8 (0.31)
Ø 20 (0.79)
3. Draw lines to interconnect all the marks.
 This will indicate the position of the five drill holes needed.
4. Drill the holes (→  3,  14).
5. Pull the display cable through the hole in the middle, and place the display from the
outside through the four holes drilled for this purpose, ensuring that the torx screws
have been unscrewed to the last half turn but are still in place. Ensure that the rubber
frame (seal, highlighted blue) does not become damaged and is properly positioned on
the surface of the door.
6. Connect the display cable to the RJ-45 socket in the base module.