Endress+Hauser Liquiline CM442R - Post-Installation Check

Installation Liquiline CM442R/CM444R/CM448R
18 Endress+Hauser
a
b
c
7. Place the mounting plate on the inside over the screws (a), slide it down (b) and tighten
the screws (c).
 The display is now mounted and ready to use.
 4 Mounted display
NOTICE
Incorrect installation
Damage, e.g. to the cable, or malfunctions are possible!
‣
Lay cables in such a way that they do not get squashed e.g. when closing the cabinet door.
‣
Plug the display cable only into the RJ45 socket in the base module. Otherwise, the display
will not function.
4.3 Post-installation check
1. After mounting, check all devices (controller, power unit, display) for damage.