Endress+Hauser Liquiline CM442R - Page 16

Installation Liquiline CM442R/CM444R/CM448R
16 Endress+Hauser
4.2.2 Wall mounting
Mounting material (screws, dowels) are not included in the scope of delivery and must
be provided by the customer.
CM444R and CM448R: The external power unit can be mounted on a DIN rail only.
Use the back of the housing to mark the mounting holes. (→  2,  13)
1. Drill the corresponding holes and insert wall plugs if necessary.
2. Screw the housing onto the wall.
4.2.3 Mounting the optional external display
L
CAUTION
Sharp-edged, non-deburred drill holes
Risk of injury, display cable may get damaged!
‣
In particular, deburr the central drill hole for the display cable.
Mounting the display on the door of the cabinet
1. Hold the mounting plate from the outside against the door of the control cabinet.
Choose the point at which you wish to install the display.
2. Make all the markings.