Liquistation CSF48
16 Endress+Hauser
Sample temperature
regulation (optional)
The temperature of the sample compartment can be adjusted using the controller. The factory setting
is 4 ˚C (39 ˚F). The current temperature is shown on the display and recorded in the internal data
logger. A temperature sensor for measuring individual sample temperatures can also be ordered as an
option.
The vaporizer and defrost heater are integrated in a special housing such that they are protected
against corrosion and damage. The compressor and condenser are located in the upper section of the
sampler, They can be easily accessed by removing the upper rear panel (for maintenance purposes).
Sampler housing Please note the mounting conditions in the "Installation" section and the information on materials for
the different housing types in the "Mechanical construction" section.
Plastic polystyrene VO can change color when exposed to direct sunlight.
In the case of a stainless steel housing, the frame around the window can change color when
exposed to direct sunlight.
For outdoor use without a weather protection cover, the use of Plastic ASA+PC V0 is
recommended.
The functionality is not affected by the discoloration.
a0013217
Cooling system
To Next Page
Loading...
