Endress+Hauser Liquisys M CLM223/253 - 3 Mounting; Quick Installation Guide; Measuring System

Liquisys M CLM223/253 Mounting
Endress+Hauser 9
3Mounting
3.1 Quick installation guide
Proceed as follows to completely install the measuring point:
• Install the transmitter (see "Installation instructions" section).
• If the sensor is not yet installed in the measuring point, install it (see Technical
Information of the sensor).
• Connect the sensor to the transmitter as illustrated in the "Electrical connection" section.
• Connect the transmitter as illustrated in the "Electrical connection" section.
• Commission the transmitter as explained in the "Commissioning" section.
3.1.1 Measuring system
A complete measuring systems comprises:
• The transmitter Liquisys M CLM223 or CLM253
• A sensor with or without an integrated temperature sensor
• A measuring cable CYK71 (conductive), CPK9 for Condumax H CLS16 or CLK5 (inductive)
Options: extension cable, junction box VBM
a0008937
Fig. 1: Complete measuring system Liquisys M CLM223/253
1
2
3
4
Conductive sensor CLS15
Liquisys M CLM253
Liquisys M CLM223
Inductive sensor CLS54
5
6
7
Inductive sensor CLS50
Conductive sensor CLS21
Immersion assembly CLA111
ENDRESS+HAUSER
LIQUISYS S
CAL REL
REL1
REL1
ALARM
REL2
REL2
E
ENDRESS+HAUSER
LIQUISYS S
CAL REL
REL1
REL1
ALARM
REL2
REL2
E
1
2
3
4
5
6
7