Endress+Hauser Micropilot FMR20 - Nameplate

Micropilot FMR20 Modbus RS485 Installation
Endress+Hauser 13
5.1.2 Nozzle installation
The antenna should project out of the nozzle for optimum measurement. The interior of the
nozzle must be smooth and may not contain any edges or welded joints. The edge of the
nozzle should be rounded if possible.
L
D
L
D
A0046282
 4 Nozzle installation
The maximum nozzle length L depends on the nozzle diameter D.
Please note the limits for the diameter and length of the nozzle.
80 mm (3 in) antenna, installation inside nozzle
• D: min. 120 mm (4.72 in)
• L: max. 205 mm (8.07 in) + D × 4.5
80 mm (3 in) antenna, installation outside nozzle
• D: min. 80 mm (3 in)
• L: max. D × 4.5