XA01554F-A Micropilot FMR67
16 Endress+Hauser
Position 5 (Housing)
Selected option Description
FMR67 B GT18 dual compartment, 316L
C GT20 dual compartment, Alu, coated
Position 7, 8 (Antenna)
Selected option Description
FMR67 GA Drip-off, PTFE DN50
GP PTFE flush mount DN80
Position 9, 10 (Seal)
Selected option Description
FMR67 A3 FKM Viton GLT, -40...80°C/-40...176°F
A5 FKM Viton GLT, -40...150°C/-40...302°F
A6 FKM Viton GLT, -40...200°C/-40...392°F
Position 11-13 (Process Connection)
Selected option Description
FMR67 AxJ Flange (different sizes), 316/316L
CxJ Flange (different sizes), 316L
GGJ Thread ISO228 G1-1/2, 316L
KxJ Flange (different sizes), 316L
RGJ Thread ANSI MNPT1-1/2, 316L
XxA Align. device (different sizes)
XxG Flange (different sizes), PP
XxJ Flange (different sizes), 316L
Position 14 (Air Purge Connection)
Selected option Description
FMR67 A W/o
1 G1/4
2 NPT1/4
Optional specifications
No options specific to hazardous locations are available.
Safety instructions: General
•
Staff must meet the following conditions for mounting, electrical installation, commissioning and
maintenance of the device:
– Be suitably qualified for their role and the tasks they perform
– Be trained in explosion protection
– Be familiar with national regulations
• Install the device according to the manufacturer's instructions and national regulations.
• Do not operate the device outside the specified electrical, thermal and mechanical parameters.
• Only use the device in media to which the wetted materials have sufficient durability.
To Next Page
Loading...
