Endress+Hauser NRF81 - Page 144

Operating menu Tankside Monitor NRF81
144 Endress+Hauser
Process variable 
Navigation  Setup → Advanced setup → Input/output → Analog I/O → Process variable
Prerequisite Operating mode (→  138) = 4..20mA input or HART master+4..20mA input
Description Defines the type of measuring variable.
Selection • Level linearized
• Temperature
• Pressure
• Density
Factory setting Level linearized
Additional information
Read access Operator
Write access Maintenance
Analog input 0% value 
Navigation  Setup → Advanced setup → Input/output → Analog I/O → Analog input 0% value
Prerequisite Operating mode (→  138) = 4..20mA input or HART master+4..20mA input
Description Value corresponding to an input current of 0% (4mA).
User entry Signed floating-point number
Factory setting 0 mm
Additional information
Read access Operator
Write access Maintenance
Analog input 100% value 
Navigation  Setup → Advanced setup → Input/output → Analog I/O → Analog input 100% value
Prerequisite Operating mode (→  138) = 4..20mA input or HART master+4..20mA input
Description Value corresponding to an input current of 100% (20mA).
User entry Signed floating-point number
Factory setting 0 mm