Endress+Hauser NRF81 - Page 185

Tankside Monitor NRF81 Operating menu
Endress+Hauser 185
Factory setting Gauge
Additional information
Read access Operator
Write access Maintenance
P3 (top) source 
Navigation  Setup → Advanced setup → Application → Tank configuration → Pressure → P3 (top)
source
Description Defines the source of the top pressure (P3).
Selection • Manual value
• HART device 1 ... 15 pressure
• AIO B1-3 value
• AIO C1-3 value
• AIP B4-8 value
• AIP C4-8 value
Factory setting Manual value
Additional information
Read access Operator
Write access Maintenance
P3 (top)
Navigation  Setup → Advanced setup → Application → Tank configuration → Pressure → P3 (top)
Description Shows the pressure (P3) at the top transmitter.
Additional information
Read access Operator
Write access -
P3 (top) manual pressure 
Navigation  Setup → Advanced setup → Application → Tank configuration → Pressure → P3 (top)
manual pressure
Prerequisite P3 (top) source (→  185) = Manual value
Description Defines the manual value of the top pressure (P3).
User entry –2.5 to 2.5 bar
Factory setting 0 bar