Endress+Hauser NRF81 - Page 200

Operating menu Tankside Monitor NRF81
200 Endress+Hauser
HTG parameters
H
P1
H
P1-P2
g
P1
P2
P3
L
HTG
H
P3
ρ
P
ρ
V
ρ
A
A0028711
 53 HTG parameters
Parameter Navigation path
P1 (Bottom pressure) Setup → Advanced setup → Tank configuration → Pressure → P1 (bottom)
H
P1
(Position of P1 transmitter) Setup → Advanced setup → Tank configuration → Pressure → P1 position
P2 (Middle pressure) Setup → Advanced setup → Tank configuration → Pressure → P2 (middle)
H
P1-P2
(Distance between P1 and P2 transmitters) Setup → Advanced setup → Tank configuration → Pressure → P1-2 distance
P3 (Top pressure) Setup → Advanced setup → Tank configuration → Pressure → P3 (top)
H
P3
(Position of P3 transmitter) Setup → Advanced setup → Tank configuration → Pressure → P3 position
ρ
P
(Density of the product
1)
) • Read-only: Setup → Advanced setup → Calculation → HTG → Density value
• Writable: Setup → Advanced setup → Calculation → HTG → Manual upper density
ρ
V
(Vapor density) Expert → Application → Tank configuration → Density → Vapor density
ρ
A
(Ambient air temperature) Setup → Advanced setup → Tank configuration → Density → Air density
g (Local gravity) Expert → Application → Tank Calculation → Local gravity
L
HTG
(Calculated level) Setup → Advanced setup → Calculation → HTG → Tank level
1) Depending on the HTG mode parameter (→  206) this is a writable or a read-only parameter.