Endress+Hauser Profi Bus Levelflex M FMP40 - Post-Installation Check

Levelflex M FMP40 with PROFIBUS PA Mounting
Endress + Hauser 35
3.4.11 Turn housing
After mounting, the housing can be turned 350° in order to simplify access to the display and the
terminal compartment. Proceed as follows to turn the housing to the required position:
• Undo the fixing screws (1)
• Turn the housing (2) in the required direction
• Tighten up the fixing screws (1).
L00-FMP4xxxx-17-00-00-en-028
3.5 Post-installation check
After the measuring instrument has been installed, perform the following checks:
• Is the measuring instrument damaged (visual check)?
• Does the measuring instrument correspond to the measuring point specifications such as process
temperature/pressure, ambient temperature, measuring range, etc.?
• Are the measuring point number and labeling correct (visual check)?
• Is the measuring instrument adequately protected against rain and direct sunlight (see → ä 88)?
1
1
2
2
F12/F23 housing T12 housing
allen key
4 mm/0.1”