Commissioning Levelflex M FMP40 with PROFIBUS PA
80 Endress + Hauser
Horizontal-Zoom-Modus
Press
O
or
S
, to switch to the envelope curve navigation. You are then in Horizontal Zoom mode.
Either or is displayed.
You now have the following options:
•
O
increases the horizontal scale.
•
S
decreases the horizontal scale.
L00-FMPxxxxx-07-00-00-xx-001
Move-Modus
Then press
F
, to switch to Move mode. Either or is displayed.
You now have the following options:
•
O
shifts the curve to the right.
•
S
shifts the curve to the left.
L00-FMPxxxxx-07-00-00-xx-002
Vertical-Zoom-Modus
Press
F
, once more to switch to Vertical Zoom mode. is displayed.
You now have the following options:
•
O
increases the vertical scale.
•
S
decreases the vertical scale.
The display icon shows the current zoom factor ( to ).
L00-FMPxxxxx-07-00-00-xx-003
Exiting the navigation
•Press
F
again to run through the different modes of the envelope curve navigation.
•Press
O
and
S
to exit the navigation. The set increases and shifts are retained. Only when you
reactivate the "recording curve"(0E2) function does the Levelflex use the standard display
again.
O
S
O
S
O
S
⇒
⇓
After 3 s, the following message appears
ENDRESS + HAUSER
E
+
–
To Next Page
Loading...
