Endress+Hauser Proline Promag L 400 - Access to the Operating Menu Via the Operating Tool; System Integration; Commissioning; Function Check

Proline Promag L 400 System integration
Endress+Hauser 53
8.4 Access to the operating menu via the operating tool
For detailed information about access to the operating menu via operating tool, refer to
the Operating Instructions for the device (→  10).
9 System integration
For information on system integration, see the Operating Instructions for the device
(→  10).
10 Commissioning
10.1 Function check
Before commissioning the device, make sure that the post-installation and post-connection
checks have been performed.
• "Post-installation check" checklist (→  24)
• "Post-connection check" checklist (→  40)
10.2 Switching on the measuring device
After a successful function check, switch on the measuring device.
After a successful startup, the local display switches automatically from the startup display to
the operational display.
If nothing appears on the local display or a diagnostic message is displayed, refer to the
Operating Instructions for the device (→  10)
10.3 Configuring the device address via software
In the "Communication" submenu the device address can be set.
Navigation
"Setup" menu → Communication → Device address
10.3.1 Ethernet network and Web server
When delivered, the measuring device has the following factory settings:
IP address 192.168.1.212
Subnet mask 255.255.255.0
Default gateway 192.168.1.212