Endress+Hauser Proline Prosonic Flow B 200 - Commissioning; Function Check; Switching on the Measuring Device

Proline Prosonic Flow B 200 Commissioning
Endress+Hauser 35
8.3.2 Via service interface (CDI)
+
E
–
12
3
A0014019
1 Service interface (CDI = Endress+Hauser Common Data Interface) of the measuring device
2 Commubox FXA291
3 Computer with "FieldCare" operating tool with COM DTM "CDI Communication FXA291"
9 Commissioning
9.1 Function check
Before commissioning the device, make sure that the post-installation and post-connection
checks have been performed.
• "Post-mounting check" checklist (→  18)
• "Post-connection check" checklist (→  25)
9.2 Switching on the measuring device
After a successful function check, switch on the measuring device.
After a successful startup, the local display switches automatically from the startup display to
the operational display.
If nothing appears on the local display or a diagnostic message is displayed, refer to the
device's operating instructions which can be found on the CD-ROM supplied with the
device.