Endress+Hauser Promag 300 - Authorized Personnel; Personnel Authorized for Alteration; Personnel Authorized for Nameplate Affixing

EA01164D
4 Endress+Hauser
1 Overview of modification kits
The modification instructions apply to the following order structures:
Order structure Procedure Contents
DK8009-
Activation of application package for Promass
300
Software code, wired-on tag plate, wire
cable with crimp sleeve, nameplate (front
foil, optional), Installation Instructions
DK8011-
Activation of application package for Promass
500, 500-digital
Software code, wired-on tag plate, wire
cable with crimp sleeve, nameplate (front
foil, optional), Installation Instructions
DK5009- Activation of application package for Promag 300
Software code, wired-on tag plate, wire
cable with crimp sleeve, nameplate (front
foil, optional), Installation Instructions
DK5011-
Activation of application package for Promag 500,
500-digital
Software code, wired-on tag plate, wire
cable with crimp sleeve, nameplate (front
foil, optional), Installation Instructions
DKZ004–
Switching I/O for Promass/Promag 300, 500,
500-digital
Software code, wired-on tag plate, wire
cable with crimp sleeve, nameplate (front
foil, optional), Installation Instructions
Upgrading of I/O hardware for Promass/Promag
300, 500, 500-digital
I/O hardware, software code (except for
relays), wired-on tag plate, wire cable with
crimp sleeve, nameplate (front foil,
optional), Installation Instructions
2 Personnel authorized to carry out modification
Authorization to carry out a conversion depends on the measuring device's approval type. The
table below shows the authorized group of people in each case.
2.1 Activating application packages / switching the I/O function:
Measuring device approval Personnel authorized to carry out modification
1)
Without approval 1, 2, 3
With approval (e.g. IECEx) 1, 2, 3
For custody transfer 4
1) 1 = Qualified specialist on customer side, 2 = Service technician authorized by Endress+Hauser,
3 = Endress+Hauser (return measuring device to manufacturer)
4 = Check with local approval center if installation/modification must be performed under supervision.