Endress+Hauser Promass - Identification; Device Designation; Certificates and Approvals

Identification Heating jacket for Promass A, E, H, I, M, S, P
6 Endress+Hauser
2 Identification
2.1 Device designation
• Promass M and I: The heating jackets consist of two half-shells.
• Promass A: The heating system consists of a heating plate.
• Promass E, H, S, P: The heating system consists of two heating plates.
2.1.1 Nameplate
a0006934
Fig. 1: Nameplate specifications for heating jackets (example)
1 Ordering code: See the specifications on the order confirmation for the meanings of the individual letters and digits.
2 Serial number / year of manufacture
3 Heating jacket material
4 Process connection of the heating jacket
5 Maximum permitted pressure (heating medium)
6 Maximum permitted temperature (heating medium)
7 Corresponding sensor
2.2 Certificates and approvals
The devices are designed to meet state-of-the-art safety requirements, have been tested, and left the
factory in a condition in which they are safe to operate. The devices correspond to article 3 (3) of
the EEC guideline 97/23/BG (Pressure Equipment Directive) and are laid out and manufactured
after good engineer practice.
The devices described in these Operating Instructions thus complies with the statutory require-
ments of the EC Directives. Endress+Hauser confirms successful testing of the device.
DK8HJ-XXXX
Heating Jacket
F DN50
G3/4" / RP3/4"
25bar / 375psi
+200°C / 392°F
1.4571 / 316Ti
XXXXXXXXXXXX
Ser.No.:
Order Code:
For Promass Sensor Type:
Material:
Process Connection:
p max.:
TM max.:
3.1B
321566-0001A
1
2
3
4
5
7
i
8
6