Prosonic M
Endress+Hauser 33
Product structure FMU41
010 Certificates
A Variant for non-hazardous area
E NEPSI Ex nA II T6
G ATEX II 3G EEx nA II T6
I NEPSI Ex ia IIC T6
J NEPSI Ex d(Ia) IIC T6
K TIIS EEx ia IIC T6
N CSA General Purpose
QNEPSI DIP
S FM IS Cl. I,II,III Div. 1 Gr. A-G / NI Cl.I Div.2, zone 0,1,2
T FM XP Cl. I,II,III Div. 1 Gr. A-G /zone 1,2
U CSA IS Cl. I,II,III Div. 1 Gr. A-G / NI Cl. I Div. 2, zone 0,1,2
V CSA XP Cl. I,II,III Div. 1 Gr. A-G / zone 1,2
1 ATEX II 1/2G EEx ia IIC T6
2 ATEX II 1/2D, Alu blind cover
4 ATEX II 1/2G EEx d (ia) IIC T6
5ATEX II 1/3D
Y Special certificate
020 Process connection
R G 2“ threadISO 228
N NPT 2“ - 11,5 thread
YSpecial version
030 Power supply/communication
B 2 wire, 4...20mA-loop/HART
H 4 wire, 10,5...32VDC / 4-20mA HART
G 4 wire, 90...253VAC / 4-20mA HART
D 2 wire, PROFIBUS PA
F 2 wire, FOUNDATION Fieldbus
J 2-wire; 4-20mA HART, 5-point linearity protocol (in preparation)
K 2-wire; PROFIBUS PA, 5-point linearity protocol (in preparation)
L 2-wire; FOUNDATION Fieldbus, 5-point linearity protocol (in preparation)
M 4-wire 90-250VAC; 4-20mA HART,5-point linearity protocol (in preparation)
N 4-wire 10.5-32VDC;4-20mA HART,5-point linearity protocol (in preparation)
Y Special version
040 Display / on-site operation
1 Without LC display
2 With LC display VU331 incl. on-site operation
3 Prepared for remote display FHX 40
9Special version
050 Housing
A Aluminium F12 housing coated to IP 68 NEMA 6P
C Aluminium T12 housing coated to IP 68 NEMA 6P; with separate terminal compartment
D Aluminium T12 housing coated to IP 68 NEMA 6P; with separate terminal
compartment; with overvoltage protection
9Special version
060 Screw union/entry
2 M20x1.5 screw union
3G 1/2“ entry
4 NPT 1/2“ entry
5 M12 PROFIBUS-PA plug-in connector
6 7/8" FF plug
9 Special version
995 Marking
1Tagging (TAG)
2Bus address
FMU41 - Product designation
To Next Page
Loading...
