Endress+Hauser RA33 - 3.4.1 Wall Mounting; 3.4.2 Panel Mounting

Installation Batch Controller RA33
10 Endress+Hauser
3.4 Installation
3.4.1 Wall mounting
1. Use the mounting plate as the template for drilled holes, dimensions → å 4
2. Attach the batch controller to the mounting plate and fasten it in place from the rear using 4
screws.
3. Fasten the mounting plate to the wall using 4 screws.
a0014170
Fig. 7: Wall mounting
3.4.2 Panel mounting
1. Make the panel cutout in the required size, dimensions → å 5.
2. Attach the seal (item 1) to the housing.
a0014283
Fig. 8: Panel mounting
3. Screw the threaded rods (item 2) into the mounting plate (dimensions → å 4).