Endress+Hauser RA33 - 5.2.4 FieldCare Device Setup Operating Software

Batch Controller RA33 Operation
Endress+Hauser 23
5.2.4 "FieldCare Device Setup" operating software
For configuring the device using the FieldCare Device Setup software, connect the device to your
computer via the USB interface.
Establishing a connection
Proceed as follows:
1. Start FieldCare.
2. Connect the device to the computer via USB.
3. Generate project via File/New.
4. Select communication DTM (CDI Communication USB).
5. Add EngyCal
®
RH33 or RS33.
6. Click "Establish connection".
7. Start online configuration.
Carry out the rest of the configuration of the device according to these Operating Instructions for
the device. The entire Setup menu, i.e. all parameters listed in these Operating Instructions, is also
included in the FieldCare Device Setup.
!
Note!
During configuration with FieldCare, the device can enter undefined states! This can result in unde-
fined switching of outputs and relays.