RIA14 Installation
Endress+Hauser 25
2.3 Certificates and approvals
CE mark, declaration of conformity
The field display unit is designed to meet state-of-the-art safety requirements, has been tested
and left the factory in a condition in which it is safe to operate.
The device meets the relevant standards and directives as per EN 61 010 "Safety requirements
for electrical equipment for measurement, control and laboratory use".
The device described in these Operating Instructions thus meets the legal requirements of the
EU directives. The manufacturer confirms that the device has been tested successfully by affixing
the CE mark.
Recognized component to UL 3111-1 (pending).
CSA General Purpose (pending).
3 Installation
3.1 Incoming acceptance, transport, storage
The permitted ambient and storage conditions must be observed. The precise specifications can
be found in Section "Technical data".
3.1.1 Incoming acceptance
On receipt of the goods, check the following points:
• Are the packaging or contents damaged?
• Is anything missing from the delivery? Compare the scope of delivery with the information
you specified in the order. See also section 2.2 "Scope of delivery".
3.1.2 Transportation and storage
Note the following points:
• Pack the device so that is protected against impact for storage and transportation. The original
packaging provides optimum protection.
• The permitted storage temperature range is -40 to +80°C (-40 to +176 °F); it is possible to
store the device in the limit temperature ranges for a limited period (maximum 48 hours).
To Next Page
Loading...
