Endress+Hauser RIA14 - Configuration Via Operating Keys

Operating the field display unit RIA14
34 Endress+Hauser
5.1.2 Display symbols
5.2 Configuration via operating keys
#
Warning!
The device must be configured outside the hazardous area.
a0011261
Fig. 10: Operating keys of field display unit ("-", "+", "E")
To configure the device, first remove the housing cover. Then remove the display from the
electronics unit. The keys (+, -, E) can now be accessed.
During configuration, the display must be connected to the electronics unit. Afterwards, the
display can be positioned at the desired angle.
1 Bargraph display
1a Indicator for measuring range undershoot
1b Indicator for measuring range overshoot
2 Measured value display
Digit height 20.5 mm (0.8")
3 14-segment display for units and messages)
4 Symbol ’Programming disabled’
5Unit ’%’
6 'Fault' indicator