How to disable calibration warnings for unused channels on Endress+Hauser Raman Rxn2?
To resolve warnings about unused channels not being calibrated on your Endress+Hauser Measuring Instruments, you can individually turn off unused probes/channels in the Options > Calibration screen and select the ON/OFF marker beneath each probe’s number.
Why is the laser power low on my Endress+Hauser Measuring Instruments?
If you're experiencing low laser power with your Endress+Hauser Measuring Instruments, it could be due to a low signal in the Raman spectra. Check the Laser Power diagnostic; the laser power should register within 10 mW of the laser power setpoint. Also, if the laser diode current reaches 80% of its current limit, Raman RunTime will provide a warning and recommends service of the laser module. If it reaches 90% of its limit, it will show an error. When the laser diode current reaches its limit, the laser is in a failure state and laser power gradually starts decreasing.
General| Measurement Principle | Raman Spectroscopy |
|---|---|
| Laser Wavelength | 785 nm |
| Interface | Ethernet, USB |
| Operating Temperature | 0 to 40 °C |
| Storage Temperature | -20 to 60 °C |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Type | Raman Analyzer |
| Detector | CCD |
| Laser Power | Adjustable up to 400 mW |
| Measurement Time | Seconds to minutes |
| Humidity | 10 to 90% non-condensing |
To Next Page