Operating Instructions Raman Rxn2
8 Endress+Hauser
During operation:
1. If faults cannot be rectified, products must be taken out of service and protected against unintentional operation.
2. Keep the door closed when not carrying out service and maintenance work.
Activities while the analyzer is in operation introduce risk of exposure to hazardous materials.
Follow standard procedures for limiting exposure to chemical or biological materials.
Follow workplace policies on personal protective equipment including wearing protective clothing, goggles and
gloves and limiting physical access to analyzer location.
Clean any spills following the appropriate site policies and cleaning procedures.
There is risk of injury from the analyzer door stop mechanism.
If the enclosure needs to be open, always open the analyzer door fully to ensure the analyzer door stop engages
properly.
2.5 Product safety
The product is designed to meet local safety requirements for the intended application, and has been tested
accordingly, leaving the factory in a condition in which it is safe to operate. All applicable regulations and
international standards have been observed. Devices connected to the analyzer must also comply with the applicable
safety standards, and users should follow the probe-specific product safety instructions.
2.6 IT security
Our warranty is valid only if the device is installed and used as described in the Operating Instructions. The device is
equipped with security mechanisms to protect it against any inadvertent changes to the settings.
IT security measures, which provide additional protection for the device and associated data transfer, must be
implemented by the operators themselves in line with their security standards.
To Next Page
Loading...
Need help?
General
