Device configuration RIA16
18 Endress+Hauser
"
Caution!
Measured value 0 % and 100 % may not be identical. However, the 0 % measured value can be
larger than the 100 % measured value (invert).
7.2 Display (DISPL)
7.2.1 Dimension
DIM É Options: NO, °C, K, °F, % or TEXT
One of the units permanently stored in the display can be selected - K, °C, °F, %. Alternatively, any
unit can be configured on the 14-segment display (TEXT).
The character set consists of the following characters:
Characters A-Z, abcdhijlmnoruvwy, the digits 0-9 and the special characters: - + * / ( )
7.2.2 Configuring the editable unit (DTEXT)
DIM É DTEXT É Enter a unit that can be edited as required
To configure the editable unit, all 5 points on the 14-segment display have to be configured. Press
the E key to move on to edit the next letter. Accept the set unit with "E".
a0011266-en
Fig. 12: Configuring the editable unit
No. Description
w Press the E key to select the desired operating function.
x Press the E key to select the next point of the 5-digit 14-segment display.
y Press the + or - key to select the next/previous character for the point selected.
z If you press the +/- keys simultaneously, data entry is aborted and the operating function is displayed.
{ When you confirm the 5th position of the display with E, the entry is accepted and you change back to the
operating function.
To Next Page
Loading...
