RIA16 Installation
Endress+Hauser 9
4.3.2 Pipe mounting
The mounting bracket is suited for pipes with a diameter between 25.4…127 mm(1…5 in.). The
mounting kit consists of a mounting plate (item 1), 2 clamps (item 2) and 4 screws (item 3)
(→ å 3 and → å 4).
To install the field indicator on a pipe, proceed as follows:
a0011269
Fig. 3: Mounting the field indicator on a pipe with mounting bracket, steps a-b
a0011270
Fig. 4: Mounting the field indicator on a pipe with mounting bracket, steps c-d
Mounting kit, consisting of:
1: Mounting plate
2: Clamps for pipe mounting
3: 4 screws
4.4 Post-installation check
After installing the device, always run the following final checks:
Device condition and specifications Notes
Is the device damaged? Visual check
Is the sealing ring undamaged? Visual check
Is the device fixed securely to the wall or mounting plate? -
Is the front cover fixed tightly? -
Does the device comply with the measurement point
specifications, such as ambient temperature, measurement
range etc.?
See Section 'Technical data'
To Next Page
Loading...
