Endress+Hauser RTA421 - Description of Operating Parameters; Analogue Input Setup

6. Description of operating parameters
This chapter describes all setting up parameters of the unit including
individual values and default settings.
All actual settings can be documented in the removable parameter
listing that can be found at the end of this operating manual.
6.1 Analogue input
The analogue measured input is set up in this function group.
Once the input signal has been set up the addresses for further settings
are displayed.
Parameter Variations
Default
settings
Actual
settings
Input range
RA NG
Current input 0...20 mA, 4...20 mA,
20...4 mA, 20...0 mA
4-20
Voltage input 0...10 V, 2...10 V, 10...0 V,
10...2 V
Contactor
35