Endress+Hauser Soliswitch FTE20 - Page 11

Soliswitch FTE20 Mounting
Endress+Hauser 11
1
2
3
A0018473
 6 Installation of the flange version
1 Attach sealing ring (1) 60x48x3 mm (2.36x1.89x0.12 in) and insert rotary paddle into connecting
flange.
2 Tighten nut (2) with open-ended wrench AF 60.
3 Secure the device using 4 screws (not included in the scope of delivery).
4.3.3 Mounting the weather protection cover
The weather protection cover is available as an accessory and can be installed without
disassembling the point level switch. The dimensions are provided in the "Technical data"
section →  19,  31.