Enfinity 1000TL - Run the Inverter

23
Step 6
Connect AC connector to inverter (see figure 25).
max. 4mm
2
communication
Figure 25
6.8 Run the inverter
•Startinverteraftercheckingallstepsdetailedbelow
a. Make sure all the DC connections and AC breakers are disconnected.
b. Make sure the AC cable is connected to the grid correctly.
NOTE:
ExceedingthemaximuminputvoltagecandestroytheEnnityinverter!
•Checktheconnectioncablesofthesolarmodulesforcorrectpolarityandthat
the maximum input voltage of the Enfinity inverter is not exceeded.
•Donotconnectstringswithanopencircuitvoltagegreaterthanthemaximum
input voltage of the Enfinity inverter.
•Checkthesystemdesigniftheopencircuitvoltageofthesolarmodulesisless
than10%belowthemaximuminputvoltageoftheEnnityinverter.