6 Maintenance
6. Maintenance
6.1. General
Intervals for greasing and inspections to be performed by the user:
- Daily, carried out on all configurations before the machine is put into
use for the working day.
- Every 8 operating hours, lubrication as per lubrication schedule.
Complete the service record, section 11.1. Service record following
each service.
DANGER
Check the attachment points regularly
and be alert for the formation of
cracks. Risk of personal injury and
damage to property.
WARNING
Make sure that service and
maintenance is carried out
according to the manufacturer's
recommendations. Inadequate
maintenance may cause defects on
the base machine and its equipment.
WARNING
When changing hoses, only hoses
with press couplings may be used.
Screw connections may not be used.
Risk of personal injury and damage to
property.
IMPORTANT
Review the personal and environmental risks of
hydraulic oil and grease by reading the safety
data sheets for the hydraulic oil and grease
in use. Risk of personal injury and damage to
surroundings.
34
To Next Page
Loading...