Activate Monitoring
Register the IQ Gateway to monitor the Enphase devices in Enphase Installer App at Enphase Installer
App.enphaseenergy.com. Once
you have registered the system and successfully installed the IQ
Gateway, Enphase Installer App sets up an account for the site owner. When you complete the
registration and installation, Enphase sends account information to the site owner so that they can log
in to the Enphase Installer App website and view system performance.
Method A: If the IQ Gateway is Associated with a System in Installer App
a.
On your mobile device, go to your Wi-Fi settings and disconnect from the IQ Gateway’s
AP network. This should restore Internet connectivity to your device.
b.
Return to the Installer App and tap the
Sync
button on the System Overview screen.
c.
When you have access to a computer with Internet access, log in to Enphase Installer
App and select the system name from the Activation List on the dashboard.
d.
From the activation form, open Array
Builder. To see the Array Builder demo, go
to enphase.com/support/videos.
•
If you used Installer App to build
arrays and scan device serial
numbers, the array(s) are built. Make
any
necessary adjustments in Array
Builder.
•
If you did NOT use Installer App to
build arrays and scan device serial
numbers, create the virtual array in
Array Builder using the installation
map as your reference. (You may
need to wait if the devices have not
yet reported to Enphase Installer
App.)
Method B: If the IQ Gateway is NOT associated with a System in Installer App
a.
Log into Enphase Installer App and click
Add a New System
from the installer dashboard.
b.
Enter the System, Installer, Owner, and Location information.
c.
Enter the IQ Gateway serial number.
d.
Click Save to submit the form.
e.
After the devices have reported to Enphase Installer App, open Array Builder from the
activation form, and create the virtual array, using the installation map as your reference.
To see the Array Builder demo, go to enphase.com/support/videos.
View System Performance
in Enphase Installer App
Once the array is built and the
system is activated, you can log in to
Enphase Installer App to view site
data. Enphase Installer App displays
a graphic representation of the PV
system. It also shows detailed
current and historical performance
information.
To Next Page
Loading...
Need help?
General
