M215 Installation and Operation
2013 Enphase Energy Inc. 141-00012 Rev 05
Enphase Microinverter Installation
Installing the Enphase Microinverter System involves several key steps. Each step listed here is detailed
in the following pages. Follow the instructions in this section to install Enphase M215 Microinverters.
Step 1: Measure AC Voltage at the Electrical Utility Connection
Step 2: Install the AC Branch Circuit Junction Box
Step 3: Position the Enphase Engage Cable
Step 4: Attach the Microinverters to the PV Racking
Step 5: Ground the System
Step 6: Dress the Enphase Engage Cable
Step 7: Connect the Microinverters
Step 8: Terminate the Unused End of the Engage Cable
Step 9: Connect the Engage Cable to AC Junction Box(es)
Step 10: Complete the Installation Map
Step 11: Connect the PV Modules
DANGER: DO NOT connect or disconnect the PV module and Enphase Microinverter
without first removing AC power from the PV system.
To Next Page
Loading...
