Enterasys Wireless WS-AP3705i Install Guide ix
About This Guide
The guide describes how to mount and connect cables to the Enterasys Wireless WS-AP3705i. In 
addition, this guide provides information on the product certifications and national approvals for 
the WS-AP3705i.
Who Should Use This Guide
This product should be installed and serviced by a qualified licensed technician, electrician, or 
electrical maintenance person familiar with its operation and the hazards involved. Proper 
installation, which includes wiring, mounting, fusing or other over current protection and 
grounding, can reduce the chance of electric shocks, fires, or explosion in this product or products 
used within this product.
How to Use This Guide
Read through this guide completely to familiarize yourself with its contents and to gain an 
understanding of the features and capabilities of the WS-AP3705i. A general working knowledge 
of data communications networks is helpful when setting up this module.
This preface provides an overview of this guide. A brief summary of each chapter defines the 
conventions used in this document and instructs how to obtain technical support from Enterasys 
Networks. To locate information about various subjects in this guide, refer to the following table.
Note: This guide does not provide information on configuration of the Enterasys Wireless APs. 
For information on how to configure the Enterasys Wireless APs, see the Enterasys Wireless 
Convergence Software User Guide.
Electrical Hazard: Only qualified personnel should install or service this unit.
Riesgo Electrico: Nada mas personal capacitado debe de instalar o darle servicio a esta unida.
Elektrischer Gefahrenhinweis: Installationen oder Servicearbeiten sollten nur durch 
ausgebildetes und qualifiziertes Personal vorgenommen werden.
For...  Refer to...
An overview of the WS-AP3705i features. Chapter 1, Introduction
Instructions to mount the WS-AP3705i, connect cables, and 
connect power.  Chapter 2, Installation
Specifications, environmental requirements, and physical 
properties of the WS-AP3705i. Appendix A, Specifications
Regulatory certifications and national approvals. Appendix B, Regulatory Information
Draft