Enterasys Wireless WS-AP3705i Install Guide B-1
B
Regulatory Information
This appendix provides regulatory information for the Enterasys Wireless WS-AP3705i.
Enterasys Wireless WS-AP3705i
The following regulatory information applies to the Enterasys Wireless WS-AP3705i.
United States
FCC Declaration of Conformity Statement\
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Warning: Warnings identify essential information. Ignoring a warning can lead to problems with the
application.
Warning: Changes or modifications made to the WS-AP3705i which are not expressly approved by
Enterasys could void the user's authority to operate the equipment.
Only authorized Enterasys service personnel are permitted to service the system. Procedures that
should be performed only by Enterasys personnel are clearly identified in this guide.
Note: The WS-AP3705i is in compliance with the European Directive 2002/95/EC on the restriction
of the use of certain hazardous substances (RoHS) in electrical and electronic equipment.
Draft
To Next Page
Loading...
