Enterasys Wireless WS-AP3705i
B-6
• ETSI/EN 300 328 (2.4 GHz)
• ETSI/EN 301 893 (5 GHz)
Other
• IEEE 802.11a (5 GHz)
• IEEE 802.11b/g (2.4 GHz)
• IEEE 802.11n
• IEEE 802.3af (PoE)
RoHS
• European Directive 2002/95/EC
Conditions of use in the European Community
Some EU countries allow outdoor operation with limitations and restrictions, which are described
in this section. It is the responsibility of the end user to ensure operation in accordance with these
rules, frequencies, and transmitter power output. The WS-AP3705i must not be operated until
configured for the customer’s geographic location.
European Spectrum Usage Rules
The AP configured with approved internal antennas can be used for indoor transmissions
throughout the European community as displayed in Table B-1. Some restrictions apply in
Belgium, France, Greece, and Italy.
Caution: The user or installer is responsible to ensure that the WS-AP3705i is operated according
to channel limitations, indoor / outdoor restrictions, license requirements, and within power level
limits for the current country of operation. A configuration utility has been provided with the Wireless
AP to allow the end user to check the configuration and make necessary configuration changes to
ensure proper operation in accordance with the spectrum usage rules for compliance with the
European R&TTE directive 1999/5/EC.
Caution: Please follow the instructions in this user guide to configure the WS-AP3705i.
• Each Wireless AP is configured with a default group of settings. There is the ability to change
these settings. The user or installer is responsible to ensure that each WS-AP3705i is configured
properly.
• The software within the Wireless AP automatically limits the allowable channels and output
power determined by the selected country code. Selecting the incorrect country of operation or
misidentifying the antenna being used,may result in illegal operation and may cause harmful
interference to other systems.
• This device employs a radar detection feature required for European Community operation in the
5 GHz band. This feature is automatically enabled when the country of operation is correctly
configured for any European Community country. The presence of nearby radar operation may
result in temporary interruption of operation of this device. The radar detection feature will
automatically restart operation on a channel free of radar.
• The 5 GHz Turbo Mode feature is not enabled for use on the WS-AP3705i.
• The 5150- 5350 MHz band, channels 36, 40, 44, 48, 52, 56, 60, or 64, are restricted to indoor
use only.
• The 2.4 GHz band, channels 1 - 13, may be used for indoor use but there may be some channel
restrictions.
• In France, outdoor operation is not permitted using the 2.4 - 2.454 GHz band.
Draft
To Next Page
Loading...
Need help?
General
