Enthermics DC250 - Delivery; Transportation Damage and Claims

1
MN-37072 • Rev 2 • 05/16 • Designer Series Blanket Warmer
Delivery
The appliance has been thoroughly tested and
inspected to ensure only the highest quality appliance
is provided. Upon receipt, check for any possible
shipping damage and report it at once to the delivering
carrier. See Transportation Damage and Claims section
locatedbelow.
This appliance, complete with unattached items and
accessories, may be delivered in one or more packages.
Confi rm that all standard items and options have been
received with each appliance as ordered. Save all the
information packed with the appliance.
This manual must be read and understood by all
people using or installing the appliance. Contact the
Enthermics service department if there are any questions
concerning installation, operation, or maintenance.
Register the unit online to assure prompt service in the
event of a warranty parts and labor claim.
http://www.enthermics.com/warranty-registration
Serial number is required for all inquiries.
Always include both model and serial number(s) in any
correspondence regarding the appliance.
Model: ______________________________________________
Serial Number: ______________________________________________
Purchased From: ______________________________________________
Date Installed: ____________________ Voltage: _____________
Transport and storage environmental conditions (not to exceed 15 days)
• Ambient temperature range of -40°C to +70°C (-40°F to +159°F)
• Relative humidity range of 10% to 95%, non-condensing
• Atmospheric pressure range of 50KPa to 106KPa
Operational environmental conditions
• Appliance must acclimate to room temperature in the environment it will be placed. 24 hours is recommended.
• Recommended environmental temperature range is 15°C to 32°C (60°F to 90°F).
• Recommended relative humidity is above 20%, non-condensing.
Environmental Conditions
Receipt of Appliance
All Enthermics Medical Systems appliances
are sold F.O.B. shipping point, and when
accepted by the carrier, such shipments
become the property of the consignee.
Should damage occur in shipment, do not put the
appliance into service until the damage has been
inspected by an authorized service provider.
Should damage occur in shipment, it is a matter between
the carrier and the consignee. In such cases, the carrier
is assumed to be responsible for the safe delivery of the
merchandise, unless negligence can be established on the
part of the shipper.
1. Conduct an immediate inspection while the appliance
is still in the truck or immediately a er it is moved
to the receiving area. Do not wait until a er the
appliance is moved to a storage area.
2. Do not sign a delivery receipt or a freight bill until
a proper count has been made and inspection of all
appliances are received.
3. Note all damage to packages directly on the carrier’s
delivery receipt.
4. Have the driver sign the delivery receipt. If he refuses
to sign, make a notation of this refusal on the receipt.
5. If the driver refuses to allow inspection, write the
following on the delivery receipt: Driver refuses to
allow inspection of containers for visible damage.
6. Contact the carrier’s offi ce immediately upon fi nding
damage, and request an inspection. Mail
a written confi rmation of the time, date, and the
person called.
7. Save any packages and packing material for further
inspection by the carrier.
8. Promptly fi le a written claim with the carrier and
attach copies of all supporting paperwork.
Enthermics will continue our policy of assisting our
customers in collecting claims which have been properly
fi led and actively pursued. Enthermics cannot, however,
fi le any damage claims, assume the responsibility of any
claims, or accept deductions in payment for such claims.
Transportation Damage and Claims