Section 13 Pro
rammin
69
Select Scan network for timers. NetFlash will show the compatible welding controls on the
network:
Select an IP address and then select OK. NetFlash will ask if the address should be used as the target
welding control for editing:
If Set as target IP address is selected the IP address will be shown as the target IP address:
Alternatively, the target address can be set by using the Edit button:
To add a descriptive name and/or location for the welding control, use the Add welding control function.
It is not necessary to do this if only one welding control is being used.
When a welding control has been selected as the target the parameters can be changed.
To Next Page
Loading...
