Entrust Sigma DS4 Installation And Administrator's Guide

Sigma DS4 and DS4-ES1 Installation and Administrator’s Guide 21
Set a Static IPv4 Address
CardWizard issuance software requires that the printer have the same IP address at all times.
Because the default communication method is DHCP (Dynamic Host Configuration Protocol), you
must change the address method and assign a static IP address before you can define the printer
to CardWizard software.
1. Obtain the following values from your network support personnel. Make sure that you
receive all three values:
 IP address
 Subnet mask
 Gateway address
2. Begin with the printer in Ready status. Press the U
SER
button to suspend the printer.
3. Press E
NTER to enter the menu system.
4. Press the down arrow until Configuration displays on line 3.
5. Press E
NTER to enter the Configuration menu.
a. Press E
NTER to enter the Network IPv4 menu.
b. DHCP/Static IP displays on line 3. Press E
NTER to select
an address method.
 You can set a static IP address on a printer even if it is not connected to the network.
For example, a group may set up several printers in a central location before installing
them at individual sites.
 When the printer is configured to use a static IP address, the printer’s front panel
displays the address even when the printer is not connected to a network. In addition,
the LCD displays a “+” if the network is active, or a “-” if the network is inactive, as a
prefix to the static IP address.

Entrust Sigma DS4 Specifications

General

Brand	Entrust
Model	Sigma DS4
Category	Printer
Language	English