Enviro HL SERIES - Replacement Parts

ENVIRO-TEC
26
FORM ET115.24-NOM11 (118)
REPLACEMENT PARTS
Factory replacement parts should be used wherever
possible to maintain the unit performance and
operating characteristics and the testing agency listings.
Replacement parts may be purchased through the local
Sales Representative.
Contact the local Sales Representative before attempting
any unit modications. Any modications not authorized
by the factory could result in personnel injury and
damage to the unit and could void all factory warranties
and regulatory listings.
When ordering parts, the following information must be
supplied to ensure proper part identication:
1. Complete unit model number
2. Unit hand connection (right or left hand) while
facing the direction of airow at the inlet
3. Complete part description including any numbers.
On warranty replacements, in addition to the information
previously listed, the project CO # that appears on
the unit nameplate, is required. Contact local Sales
Representative and refr to warranty policy.
All equipment and components sold through the Parts
Department are warranted under the same conditions as
the standard manufacturer’s warranty with the exception
that the warranty period is 12 months.