ProControl User’s Manual v2.2X
9 \8100\0074_1017
2.2 Keypad
The Series 2
plus
keypad contains 12 buttons which are used along with the LCD
Display to control the operations of the system. The Type C ProControl has a 4-key
keypad with more limited functionality.
Ÿ
Up
⁄
Down
Ÿ
I/O
⁄
I/O
Field
Menu
Enter
!
Ack
Hi Lo
Set
Mode
Man
Mode
Auto
Figure 3. Series
2
plus
Keypad
Menu
This key is used to scroll through a series of options which are displayed on the
LCD screen, and which allow the user to configure various aspects of system
behavior.
Ÿ
I/O
⁄
I/O
These keys are used to display information about particular I/O points on the LCD
Screen. The keys allow the user to scroll through all of the system I/O points either
forward or backward.
Ack
The Acknowledge key is used to silence the audible beeper or to acknowledge a
memo sent from a remote ProView user.
Hi Lo
Set
The Set Hi Lo key allows the user to change the high and low alarm limits for
analog inputs or to toggle the display in the I/O Summary.
!
The Emergency Shutdown key is used to turn off all outputs and return the system
to manual mode. The programmed shutdown sequence is not executed using this
key.
Field
The Field key is used to select a character position to be edited. It is used in
conjunction with any direct alphanumeric entry.
Ÿ
Up
⁄
Down
These keys are used to toggle system variables from one state to the next or to
scroll through possible character entries when used in conjunction with the Field
key.
Mode
Man
This key is used to place the system in manual mode.
Mode
Auto
This key is used to place the system in auto mode.
Enter
The Enter key is used to initiate certain actions selected by other keys or to confirm
alphanumeric editing done using other keys.
To Next Page
Loading...