ProControl User’s Manual v2.2X
19 \8100\0074_1017
MODES
Use the Up and Down keys to toggle an Analog Output from Manual control to
PID control or Proportional control, depending on which analog output process is
being used. This selection will only appear if an analog output tagname is
displayed and the analog output is part of an analog output process.
Menu
TAGNAM 100.0 PCT
>MANUAL
TAGNAM 96.3 PCT
>MANUAL
TAGNAM 25.0 PCT
>MANUAL
Ÿ
Up
⁄
Down
2.11 LED
Indicators
Your ProControl unit has three status LEDs to the left of the keypad, which are
used to indicate the following:
System Status: Normally ON when unit is powered.
One blink - The system has internally reset.
Two blinks - An internal error has occurred.
Connect: ON if user is remotely or locally connected.
ON if system is emailing, faxing or sending text message.
Slow blink - last email, fax or text message failed, press
ACK to clear.
Fast blink - local connect cable inadvertently left plugged
in or cellular data modem not found; press
ACK to clear.
Network: Rapid blinking indicates an active network connection.
To Next Page
Loading...
Need help?
General
