EOS ProControl 2 plus Series - Analog Output Configuration

ProControl User’s Manual v2.2X
13 \8100\0074_1017
2.9 Analog
Output
Menu
VRPUMP 25.0 PCT
ALARMS SET
>MANUAL
Analog Tagname
Percentage
An analog output displayed in the
operations screen will be displayed as
shown to the left. The percentage of
full scale output will be displayed as
well.
Hi Lo
Set
Hi Lo
Set
VRPUMP 25.0 PCT
OUTPUT LVL
>MANUAL
_
WTRLVL 33.0 FT
SETPOINT
>MANUAL
_
The Set Hi Lo key can be used to set
the output percentage.
Press the Set Hi Lo key again to
declare the SetPoint of an associated
analog input. The SetPoint is used
only if a PID control loop is in use as
an analog output process.
Pressing Set Hi Lo again returns to the
original menu.
Ÿ
Up
⁄
Down
VRPUMP 35.0 PCT
OUTPUT LVL
>MANUAL
_
The Up and Down keys are used to
change the value of the current
character, as denoted by the cursor.
Field
VRPUMP 35.0 PCT
OUTPUT LVL
>MANUAL
_
The Field key is used to move to the
next character to be edited.
Enter
VRPUMP 35.0 PCT
OUTPUT LVL
>MANUAL
_
To save the output level changes, press
the enter key.