EOS ProControl 2 plus Series - Analog Input Configuration

ProControl User’s Manual v2.2X
12 \8100\0074_1017
2.8 Analog
Input Menu
H2OFLO 54.6 GPM
ALARMS SET
>MANUAL
Analog Tagname
Units
Analog Value
An analog input displayed in the
operations screen will be displayed as
shown to the left. The value of the
analog input will be shown along with
the dimensional units. In the case of a
pulse accumulator (totalizer only), you
will see only TOT where units is
normally displayed.
Hi Lo
Set
H2OFLO 20.0 GPM
LOW ALARM
>MANUAL
_
Use the Set Hi Lo key to set the low
alarm limit.
Hi Lo
Set
H2OFLO 80.0 GPM
HIGH ALARM
>MANUAL
_
Press the Set Hi Lo key again to set
the high alarm limit.
Hi Lo
Set
H2OFLO 120817 GAL
TOTAL FLOW
>MANUAL
Press the Set Hi Lo key again to see
the total flow on a flow type input, and
once more to return.
Ÿ
Up
⁄
Down
H2OFLO 30.0 GPM
LOW ALARM
>MANUAL
_
The Up and Down keys are used to
change the value of the current
character, as denoted by the cursor.
Field
H2OFLO 30.0 GPM
LOW ALARM
>MANUAL
_
The Field key is used to move to the
next character to be edited.
Enter
H2OFLO 30.0 GPM
LOW ALARM
>MANUAL
_
To save the low alarm limit changes,
press the enter key.