ep RPL201 - Battery Cleaning and Life Optimization

REV. 09/2022
12
F
NOTE
The EP instrumentation is used for serviced.
Cleaning
The manufacturer recommends to only use compressed air at less than 207 kPa (30 psi) or a
slightly damp towel to clean the battery. The battery, or its charging station, may be equipped
with fans, heat sinks, or other cooling devices that require periodic cleaning. Always know
and follow the battery manufacturer's recommendations for cleaning and service.
i
Optimize Battery Life
Always use and follow the battery management system (BMS). The BMS is the electronic
system that monitors battery data and use that data to its operating environment to inuence
the battery's safety, performance, and service life. It also functions as a safety cut-o󰀨 device
in case of overcharging, overcurrent, or overheating. Lithium-ion battery life is greatly reduced
if used outside a temperature range of 0ºC to 40ºC (32ºF to 104ºF) or in an environment with
greater than 85% humidity. EP recommends to opportunity charge lithium-ion batteries.
This is when the battery is recharged for short intervals during a shift period. It reduces or
eliminates the need for long charging periods, changing batteries during a shift, and extending
shift periods.