27
RFRPD Room Thermostat CP4D
Press
MAN
to enter the manual mode (Permanent Override).
‘MAN’ will appear on the screen.
Rotate
to adjust the temperature setpoint.
Press
or after 5 seconds the thermostat will operate in this
permanent override.
To cancel permanent override, press
AUTO
to return to the automatic
mode.
When the thermostat is in the AUTO mode it will automatically change
the temperature throughout the day according to the schedule set by
the user in the
PROG
menu.
If the room temperature falls below the setpoint it will activate the
heating. See Page 8 for more information.
Note: If the heating is set to default Program 6 is 16°C. If during the
night the heating falls below 16°C it will turn on the heating. If you do
not want this to happen you should adjust P6 to a lower temperature.
Permanent Override
Auto Mode
To Next Page
Loading...
