EPH Controls CP4D - P11 Dhop; P12 Set Opentherm Parameters

49
RFRPD
OpenTherm® Instructions
This function allows the installer to activate or deactivate DHW target
temperature control from the thermostat. This menu is only available
when the thermostat is connected to OpenTherm®
This function allows the installer to congure the OpenTherm®
parameters.
To access the menu please enter the password “08” by rotating
.
Press
to conrm.
The parameters that can be set are outlined in the table on the next
page 50.
P11 DHOP
P12 Set OpenTherm® Parameters