15. Use strips of tape to position the caster wheels so that the wheels are pointing upward, and the
rubber feet are positioned down toward the back of the machine.
16. With at least 4 people, tilt the machine forward using the caster rubber feet as a pivot point, until
the machine is in its original upright orientation.
17. Once the machine is fully upright again, adjust the rear casters so that both rear wheels are back
on the ground. Remove the tape from the wheels.
18. Remove the ratcheting strap, any protective materials around the machine, as well as all tape
used to secure the door.
19. Place any table plaorms back inside the machine and finish setting up your machine as
instructed in “SECTION 2: GETTING STARTED” on page 13.
- 172 -
SECTION 10: SYSTEM MAINTENANCE
To Next Page
Loading...
