Epilog Laser FusionPro 16000 User Manual

8. On the right side of the screen you can see two processes in the process list: Engrave and Vector.
These layers automatically separated because we set the line width of cut lines to .003” (0.077 mm)
or thinner).
You can set the Dashboard to automatically separate vector lines by line thickness, color, or
no action. For more information, see “Presetting Your Cut Lines” on page 65.
- 60 -
SECTION 5: THE LASER DASHBOARD

Epilog Laser FusionPro 16000 Specifications

General

Brand	Epilog Laser
Model	FusionPro 16000
Category	Engraver
Language	English