EasyManuals Logo

Epiroc SmartROC T40 User Manual

Default Icon
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
SmartROC T35/T40 4 Safety Precautions
16 No: 5966599819.1.5966707083 en-US
Always use protective safety glasses when using a hammer, as chips or debris can
cause eye injury.
Use a hammer with a soft face when driving hardened pins.
Use a respirator in dusty conditions.
Make sure that compressed air for cleaning the machine does not exceed 2 bar (30
psi).
Wear a protective face shield and clothing when cleaning with compressed air.
4.3 Safety During Lifting, Installing, and Connecting
Make sure that the following conditions are met while lifting, installing, and connecting the
machine or its equipment:
Make sure that only authorized personnel lift, install, and connect the equipment.
Use lifting devices for lifting heavy components.
Use only approved tools and methods.
Use lifting devices that are inspected and approved and are in compliance with local
regulations.
Attach lifting devices only to specified lifting points.
Make sure that no personnel are present below suspended loads.
Use only ladders and platforms designed for that specific purpose.
4.4 Safety Precautions during Tramming
Follow local traffic regulations.
Observe that no personnel are present within the machine hazard zone or in the direc-
tion of travel.
Be cautious that impaired visibility can cause a collision risk and also severe injuries.
Always check ground conditions where the machine is in operation.
Adapt the speed to the terrain.
Never exceed the maximum allowed inclination angles for the machine.
Make sure that the boom system is set to the correct tramming position.
4.5 Safety Precautions during Operation
Check that pedals and controls are easily accessed by the operator before starting the
machine. If the controls are not accessible to the operator, the machine must not be
operated.
Make sure that all warning signals on the machine are tested before starting the ma-
chine (for example, brake lights, and turn signal).
Make sure that all controls, indicators, and fire extinguishers (optional items) are work-
ing satisfactorily.
Make sure that all warning signs and safety labels are in place, clean, and fully legible.
Always test the brakes before operating the machine.
Report any damage or defects immediately.
Keep all doors closed while the machine is in operation in order to not disrupt the flow
of cooling air and to avoid reducing the amount of noise suppression. A door can be
kept open for a short period, only if necessary.
Turn the rotation off when manually handling drill bits and drill rod.

Table of Contents

Other manuals for Epiroc SmartROC T40

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epiroc SmartROC T40 and is the answer not in the manual?

Epiroc SmartROC T40 Specifications

General IconGeneral
BrandEpiroc
ModelSmartROC T40
CategoryIndustrial Equipment
LanguageEnglish

Related product manuals