SmartROC T35/T40 3 Risks and Hazards
9 No: 5966599819.1.5966707083 en-US
3 Risks and Hazards
3.1 Stored Energy Hazard
Before operating the machine, personnel must be aware of the following information re-
garding the dangers from stored energy.
• Personnel must be aware of how the hydraulic components can move.
• Personnel must be aware of how the hydraulic system controls components.
• Personnel must be aware of how related control circuits affect the hydraulic compo-
nents.
• Personnel must prevent movement of any component that could cause personal injury
and property damage.
• Personnel must make sure that no part of the body is in a position where component
movement can cause physical injury.
• Personnel must be aware of situations where component movement cannot be pre-
vented, such as:
– If the hydraulic system fails
– If the hydraulic system disengages
– If the hydraulic system receives a control signal resulting in component move-
ment
• Personnel must release all sources of potential energy.
• Personnel must make sure that any possible component or machine movement is me-
chanically prevented.
3.2 Burn Hazard
Burn Hazard
The hot surface of the particulate filter and the exhaust pipe can cause a risk of being
burned.
To minimize risk:
• Stay clear of the particulate filter and the exhaust pipe during regeneration.
To Next Page
